• Paste Epoxies
  • PC-7
  • PC-11
  • Super Epoxy
  • Fast-N EZ
  • PC-AutoBond
• Putty Epoxies
  • PC-Metal™
  • PC-Marine™
  • PC-Plumbing™
  • PC-Crete™
  • PC-Lumber™
  • PC-Fahrenheit™
  • PC-Pool™
• Wood Repair
  • PC-Rot Terminator®
  • PC-Woody™®
  • PC-Petrifier®
  • Rotted Wood Repair Kit
• Concrete Repair & Anchoring
  • PC-Concrete™
  • PC-Masonry Epoxy™
• Joint & Crack Filler
• Clear Liquid Epoxy
• Accessories
  • Dispensing Guns
  • PC-Earth Tone Pigments™
  • Mixing Nozzles
  •  

When E-Z is what you need!

Description:
PC-Fast-N EZ™ is an extremely flexible translucent paste epoxy. Ease of use is the key with this self mixing formulation. PC-Fast-N EZ™ flows beautifully through a static mix nozzle that mixes the epoxy thoroughly. The mixing nozzle doesn't just mix the product; it also helps with precise applications. PC-Fast-N EZ™ has a fast cure time, making jobs complete and easy as 1-2-3!
Bonds most everything to anything.
***Note: PC-Super Epoxy® will not bond to wax paper, Teflon®, Polyethylene, and some other plastics. There are hundreds of plastics in thousands of combination. Test a small area when in doubt.

Directions:

• Remove plastic cap from center of plunger (retain); snap off end of syringe (discard).
• Push plunger until epoxy dispenses evenly.
• Push and twist nozzle over opening locking nozzle into position. Be sure the nozzle snaps into place past prongs. NOZZLE MUST BE LOCKED IN PLACE PRIOR TO USING.
• Depress plunger evenly and slowly dispense mixed epoxy directly onto the surface
• After you have finished using the syringe, remove the nozzle and discard.
• Wipe the syringe end after removing the nozzle. Place plastic cap onto the end of syringe and store for future use.

***Note: If both mixing nozzles have been used; remaining epoxy may be dispensed onto a flat surface and mixed with a tool. Surfaces to be bonded must be free of dirt, oil, rust, etc. Denatured alcohol can be used to prepare the surface. For best results, rough up the surface that PC-Fast-N EZ™ will be bonding to.

Apply PC-Fast-N EZ™ in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample PC-Fast-N EZ™ remains between the contact surfaces.

After cure: Paint Drill, Machine, Sand, File, Tap, or Saw.

Additional Information