PC-FAST-n EZ™
Description:
PC-Fast-N EZ™ is an extremely flexible translucent paste epoxy. Ease of use is the key with this self mixing formulation. PC-Fast-N EZ™ flows beautifully through a static mix nozzle that mixes the epoxy thoroughly. The mixing nozzle doesn’t just mix the product; it also helps with precise applications. PC-Fast-N EZ™ has a fast cure time, making jobs complete and easy as 1-2-3!
Bonds most everything to anything.
***Note: PC-Super Epoxy® will not bond to wax paper, Teflon®, Polyethylene, and some other plastics. There are hundreds of plastics in thousands of combination. Test a small area when in doubt.
Directions:
Remove plastic cap from center of plunger (retain); snap off end of syringe (discard).
Push plunger until epoxy dispenses evenly.
Push and twist nozzle over opening locking nozzle into position. Be sure the nozzle snaps into place past prongs. NOZZLE MUST BE LOCKED IN PLACE PRIOR TO USING.
Depress plunger evenly and slowly dispense mixed epoxy directly onto the surface
After you have finished using the syringe, remove the nozzle and discard.
Wipe the syringe end after removing the nozzle. Place plastic cap onto the end of syringe and store for future use.
***Note: If both mixing nozzles have been used; remaining epoxy may be dispensed onto a flat surface and mixed with a tool. Surfaces to be bonded must be free of dirt, oil, rust, etc. Denatured alcohol can be used to prepare the surface. For best results, rough up the surface that PC-Fast-N EZ™ will be bonding to.
Applications:
Apply PC-Fast-N EZ™ in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample PC-Fast-N EZ™ remains between the contact surfaces.
After cure: Paint Drill, Machine, Sand, File, Tap, or Saw.
PC-Fast-N EZ™ has hundreds if not thousands of uses.
Bonds: Wood, Metal (all types), Glass, Brick, Block, Rubber, Concrete, Stone, Slate, Fiberglass, tile, and more in any and all combinations.
|
